. MAINTENANCE MAINTENANCE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE WARNING The oil is at high temperature after the engine has been operated, so never replace the cartridge immediately after finishing operations. Always use a genuine Komatsu part for the cartridge. LUBRICATING FAN PULLEY ASSEMBLY, TENSION PULLEY ASSEMBLY Using a grease gun, pump in grease through the grease fittings shown by arrows. (1) Fan pulley assembly (1 points) (2) Tension pulley assembly (1 points) Always wipe off the grease that it is squeezed out from the breather. 4 - 74 Wait for the oil to c ool down before replacing cartridge.
Container to c atch coolant wrench ) of corrosion resistor (2) to the CLOSE stopper er under the cartridge to catch the coolant. Prepare a filter 1. Turn valve (1 position. 2. Set a contain 3. Using a filter 4. Clean the fil cartridge thin wrench, turn cartridge ( ter holder, coat the s ly with oil, then install th 2) to the eal surfa e cartrid left to remove it. ce of the new ge. 5. When installin g the cartridge, bring th e packin g surface i nto c ontact with the seal surfa tighten a furth If the filter car will leak from er 2/3 times. tridge is tightened too fa r, the gas ket wil l be damaged and coolant will lea the gap in the gasket, so alway s keep the 6.
Turn valve (1 ) of corrosion resistor ( 2) to the OPEN stopper 7. After replacin g the cartridge, run the engine, a nd check for any leakage of water from any water lea kage is found, check th e tighten ing of the filte r cartridge.