OM3214 Operation - Section 3 Operator Cab and Controls Page 32-9 STATEX III DOWNLOAD PORT This connector (13, Figure 32-7) is for use by quali- fied personnel to access G.E. STATEX III electric pro- pulsion diagnostic information and data. PAYLOAD METER The Payload Meter (1, Figure 32-7) and Download Connector (2) are used to provide management with operational data such as tonnage hauled and cycle times. KOMATSU ENGINE CENSE CONNECTOR Refer to Section 6, Optional Equipment, for a more complete description of the payload meter and its functions. This 3-pin connector (14, Figure 32-7) is for use by qualified personnel to access engine diagnostic infor- mation for the CENSE system.
Refer to engine man- ufacturer’s service publications for troubleshooting information. PAYLOAD METER DOWNLOAD CONNECTOR This connector (2, Figure 32-9) is used with a special cable to allow the Payload Meter (1) to communicate with a Portable Computer. MODULAR MINING PORT This connector (15, Figure 32-7) location is used if the optional Modular Mining System is installed on the truck. PASSENGER SEAT The Passenger Seat (16, Figure 32-7) is mounted on top of the right hand portion of the Center Console structure. The area beneath the passenger seat provides a cabinet for various 24 VDC electrical components. Consult the Service Manual for service involving any of these components.
Centry™ Fuel Control DIAGNOSTICS DOWNLOAD PORT This connector (17, Figure 32-7) is for use by quali- fied personnel to access the Engine Centry™ Fuel Control system diagnostic information. ENGINE DIAGNOSTICS PORT This connector (18, Figure 32-7) is used by qualified personnel to access engine diagnostic information. FIGURE 32-9. PAYLOAD METER DATA STORAGE BUTTON 1. Payload Meter 2. Download Connector This button (19, Figure 32-7) is for use by qualified maintenance personnel to record in memory a “snap- shot” of the Statex III drive system.