hitachi — DISASSEMBLE MAIN PUMP

UPPERSTRUCTURE / Pump Device 11. Tap and remove support (28) from pump casing (26) by using a plastic hammer. At this time, remove O-rings (27, 39, 40) and spring pin (11). 12. Remove swash plate (30) and shoe plate (31) from pump casing (26). 13. Tap and remove drive shaft (5) from support (28) by using a plastic hammer. 14. Remove plugs (24) (2 used) and orifices (25) (2 used) from pump casing (26). IMPORTANT: Do not remove needle bearing (38) unless necessary. 18. Remove needle bearing (38) from cover (52). 19. Remove socket bolts (49) (3 used) from cover (48). Remove cover (48) and O-rings (39, 40) from cover (52). : 5 mm 20. Remove retaining ring (8) from drive shaft (5).

Remove spacer (7) and roller bearing (6) from drive shaft (5). : 2.5 mm, 5 mm 15. Install the bolt (M5, Pitch: 0.8 mm) to stoppers (12, 21). Remove stoppers (12, 21) from pump casing (26). 16. Remove backup rings (13, 20) and O-rings (14, 19) from stoppers (12, 21). IMPORTANT: LOCTITE has been applied onto the contacting part between servo piston (18) and tilt pin (15). Do not disassemble them. 17. Heat tilt pin (15) by using a drier. Secure servo piston (18) by using a pair of pliers in order not to damage. Rotate and remove tilt pin (15). Remove servo piston (18) from pump casing (26). W2-4-31