hitachi — DISASSEMBLE MAIN REGULATOR

UPPERSTRUCTURE / Pump Device 15. Remove O-rings (52, 55) from supporting plugs (51, 56). IMPORTANT: Do not remove pin (19) from lever (18). 16. Remove lever (18) from casing (37) by using a pair of tweezers. 17. Remove pin (16) from feedback lever (15) by using a round bar (Dia. 3 mm (0.12 in)). Remove feedback lever (15) from casing (37). IMPORTANT: Do not remove pin (13) from lever (14). 18. Remove lever (14) from casing (37). 19. Remove pilot piston (24) from casing (37). 20. Insert a round bar (Dia. 3 mm (0.12 in)) into the pilot piston (24) side. Remove spring seat (23), spring (22) and stopper (21) from casing (37). 21. Remove O-ring (20) from stopper (21). 22. Insert a round bar (Dia.

3 mm (0.12 in)) into the adjusting screw (40) side. Remove compensating rod (7) and the sleeve (5) assembly from casing (37). 23. Remove compensating rod (7), compensating piston (6) and O-ring (4) from sleeve (5). 24. Remove spool (25) from casing (37). W2-4-43