UPPERSTRUCTURE / Pump Device Assemble Main Regulator IMPORTANT: Check the direction to install compensating rod (7) as illustrated. 1. Insert compensating rod (7) into casing (37). 2. Install pin (13) to lever (14). Insert lever (14) into casing (37). Align pin (13) with the groove of compensating rod (7) and install pin (13). 3. Install retaining ring (27) to sleeve (26). IMPORTANT: After inserting, check if spool (25) moves smoothly. 4. Insert sleeve (26) and spool (25) into casing (37). IMPORTANT: Check the direction to install feed back lever (15). 5. Align the pin hole (the hole in upper side) in feed back lever (15) with that in spool (25). Install pin (16). IMPORTANT:
After inserting, check if pilot piston (24) moves smoothly. 6. Insert pilot piston (24) into casing (37). 7. Install O-rings (52, 55) to supporting plugs (51, 56). IMPORTANT: As supporting plugs (51, 56) are quite similar, align the matching marks and install plugs (51, 56). 8. Align pin (19) in lever (18) with the groove in pilot piston (24). Install pin (19). 9. Install pin (50) to supporting plug (51). Align with the pin holes of lever (18) and install supporting plug (51). 10. Install lock ring (53) to the groove on supporting plug (51) in casing (37). 11. Install supporting plug (56) to casing (37). Install lock ring (54) to the groove on supporting plug (56). 12.
Install spring (29) and spring seat (30) to spool (25). Secure spring seat (30) to spool (25) with retaining ring (31). 13. Install spring (28) to casing (37). Lever (26) Side Compensating Rod (7) Side W18B-02-04-018 W2-4-47