hitachi — DISASSEMBLE FAN PUMP

UPPERSTRUCTURE / Pump Device Disassemble Fan Pump IMPORTANT: As the setting of flow rate changes, do not remove adjusting screws (10, 44) and nuts (9, 45) from support (30) and cover (46). 1. Remove plugs (17) (2 used) and O-rings (18) (2 used) from pump casing (27). Drain off hydraulic oil from the pump. 5. Remove cylinder block (38) from pump casing (27). Plungers (34) (9 used) and spherical bushing (36) and retainer (35) are removed with cylinder block (38) together. NOTE: Rotate cylinder block (38) clockwise and counterclockwise by hands and remove cylinder block (38) slowly. 6. Remove retainer (35) from the cylinder block (38) assembly.

Plungers (34) (9 used) are removed with retainer (35) together. 7. Remove plungers (34) (9 used) from retainer (35). 8. Remove spherical bushing (36) from cylinder block (38). Remove springs (37) (9 used) from cylinder block (38). IMPORTANT: Do not remove oil seal (4) unless necessary. When removing oil seal (4), replace with the new one. Oil seal (4) is installed to cover (2). When removing cover (2), do not damage the lip part of oil seal (4). 9. Remove socket bolts (1) (4 used) from cover (2). Remove cover (2) and O-ring (3). : 27 mm 2. Remove socket bolts (21) (6 used) from regulator (20). Remove regulator (20) from pump casing (27). : 6 mm 3.

Place pump casing (27) with the mounting surface for regulator (20) facing downward. IMPORTANT: When removing cover (46), valve plate (39) may be removed together. Do not remove needle bearing (40) unless necessary. When removing needle bearing (40), replace with the new one. 4. Remove socket bolts (31) (4 used) from support (30). Remove cover (46), O-ring (41), (26) (4 used), spring pin (11), valve plate (39) and pin (47) from pump casing (27). : 5 mm : 14 mm NOTE: Insert the bolt into the hole (M8) on cover (2) for easy removal. W2-4-51