hitachi — ASSEMBLE FAN PUMP

UPPERSTRUCTURE / Pump Device Assemble Fan Pump IMPORTANT: Apply THREEBOND #1305N to the contacting part between servo piston (22) and tilt pin (19). 1. Install O-rings (14, 23) and backup rings (13, 24) to stoppers (12, 25). 2. Install tilt pin (19), servo piston (22) and the stoppers (12, 25) assembly to pump casing (27). 3. Install spacer (6), roller bearing (7), spacer (6) and retaining ring (8) to shaft (5). 4. Install O-rings (26) (2 used) to pump casing (27). Install spring pin (11) and O-ring (28) to support (30). Lightly tap and install support (30) to pump casing (27) by using a plastic hammer. 5. Place pump casing (27) with the mounting surface for regulator facing downward. 6.

Align swash plate (32) to which shoe plate is installed with tilt pin (19). Install swash plate (32) to pump casing (27). NOTE: After installing swash plate (32), check if swash plate (32) moves by hand smoothly. IMPORTANT: Apply lubricant to the outer surface of oil seal (4) and apply grease to the lip part. 7. Install oil seal (4) and O-ring (3) to cover (2). 8. Install drive shaft (5) to support (30). Install cover (2) to support (30) with socket bolts (1) (4 used). : 5 mm : 12 N m (1.2 kgf m, 8.9 lbf ft) 9. Install springs (37) (9 used) and spherical bushing (36) to cylinder block (38). 10. Install plungers (34) (9 used) to retainer (35).

Install the retainer (35) assembly to cylinder block (38). 11. Install the cylinder block (38) assembly to drive shaft (5). W2-4-55