UPPERSTRUCTURE / Swing Device Assemble Swing Device IMPORTANT: Face the oil groove of thrust plate (5) upward. 1. Install thrust plate (5) to first stage carrier (6). 2. Install needle bearing (16) to first stage planetary gear (17). IMPORTANT: Install thrust plate (15) with the oil groove facing to the planetary gear side. Install the thrust plate while matching the bending part with the carrier. 3. Install first stage planetary gear (17) and thrust plates (15) (2 used) to first stage carrier (6). 4. Align with the spring pin (13) on first stage carrier (6) and install pin (18). 5. Tap and install spring pin (13) to first stage carrier (6) and pin (18) by using a round bar and hammer.
Round bar ( φ 5.0 mm, Length: 50 mm or longer) IMPORTANT: Apply grease to O-ring (33) and LOCTITE #262 to screw (30). 8. Install screws (30) (4 used), magnets (31) (4 used) and O-ring (33) to sleeve (32). IMPORTANT: Apply THREEBOND #1215 to the oil seal mounting surface on cover (27) and grease to the lip part of oil seal (29) respectively. 9. Install oil seal (29) to cover (27). 10. Install the cover (27) assembly to sleeve (32). 11. Install the sleeve (32) assembly to shaft (34). 12. Install bearing (25) to shaft (34) by using a press. CAUTION: Housing (22) weight: 145 kg (320 lb) 13. Place housing (22) to the press stand with the motor mounting surface facing downward. 14.
Install O-ring (26) to housing (22). 15. Install the shaft (34) assembly to housing (22) by using a press. Install cover (27) to housing (22) with socket bolts (28) (10 used). NOTE: At this time, face the split part of spring pin (13) to the end of pin (18) (motor side). 13 18 Motor Side Slit : 90 N m (9 kgf m, 66 lbf ft) : 10 mm W178-02-06-002 6. Install other planetary gears (17) to first stage carrier (6). 7. Assemble second stage carrier (8) in the procedures as steps 1 to 6. CAUTION: Housing (22)+shaft (34)+others: 265 kg (585 lb) 16. Turn over housing (22). Install bearing (10) to housing (22) and shaft (34) by using a press. NOTE: Thrust plate (11) is not bent.
The needle bearing is not used for second stage planetary gear (12). W2-6-11