UPPERSTRUCTURE / Swing Device Disassemble Swing Motor 7. Remove valve plate (9) from valve casing (3). 8. Remove springs (10) (16 used) from casing (30). CAUTION: The swing motor assembly weight: 70 kg (155 lb) 1. Drain hydraulic oil from the drain port on casing (30) in the swing motor. IMPORTANT: Do not disassemble relief valve (14). 2. Remove relief valves (14) (2 used) from valve casing (3). NOTE: When removing springs (10) (16 used), check the mounting position of springs (10) (16 used). 9. Remove socket bolts (42) (3 used). Remove swing parking brake valve (39) and O-rings (40, 41) from casing (30). : 41 mm 3. Remove plugs (8) (2 used) from valve casing (3). : 14 mm 4.
Remove springs (6) (2 used) and poppets (5) (2 used) from valve casing (3). 5. Put the matching marks on the contacting surfaces on valve casing (3) and casing (30). Remove socket bolts (4) (4 used). : 5 mm IMPORTANT: Do not damage the contacting surfaces due to the screwdriver. Put the matching marks on brake piston (11) and casing (30). Measure and record dimension between the upper surfaces on casing (30) and upper surfaces on brake piston (11). (necessary when assembling) 10. Apply air through part A by using an air compressor. Float and remove brake piston (11) from casing (30). : 17 mm NOTE: Valve casing (3) is floated by springs (10) (16 used). 6.
Remove valve casing (3) from casing (30). NOTE: Remove valve casing (3) carefully as valve plate (9) falls off. Do not drop valve plate (9). 11 A 30 W800-02-06-006 W2-6-15