hitachi — DISASSEMBLE SWING MOTOR

UPPERSTRUCTURE / Swing Device 11. Remove O-rings (12, 17) from casing (30). 12. Place casing (30) horizontally with the swing parking brake valve (39) side facing upward. At this time, place a wooden block under casing (30) with casing (30) horizontal. 13. Remove rotor (23) from shaft (31). At this time, plunger (28) and retainer plate (27) are removed with rotor (23) together. 19. Remove the outer race of roller bearing (1) from valve casing (3) by using a puller. Remove O-ring (2) and pins (15) (2 used) from valve casing (3). IMPORTANT: Do not remove the inner race of roller bearing (1) unless necessary. 20. Remove retaining ring (16) from shaft (31). 21.

Remove retaining rings (32) (2 used), spacers (33) (2 used), the inner ring plate and outer race of roller bearing (34) from shaft (31). 22. Remove the inner race of roller bearing (34) from shaft (31) by using a press. At this time, remove the inner race from the roller bearing (1) side. 23. Remove plungers (28) (9 used), retainer plate (27), holder (26), spacer (25) and push rods (24) (12 used) from rotor (23). NOTE: When it is difficult to remove rotor (23), plate (18) and friction plate (13) are inclined. Push in plate (18) and friction plate (13) by using a round bar. 14. Remove plates (18) (4 used) and friction plates (13) (3 used) from casing (30). 15.

Remove retaining ring (38) from casing (30). Remove seal cover (37) from casing (30). 16. Tap the roller bearing (1) side by using a plastic hammer lightly and remove shaft (31) from casing (30). At this time, roller bearing (34) is removed with shaft (31) together. 17. Remove shoe plate (29) from casing (30). 18. Remove oil seal (36) from seal cover (37) by using a screwdriver and hammer. CAUTION: Push spacer (20) by using a press when removing retaining ring (19). If removing only retaining ring (19), spacer (20) and spring (21) may fly out. 24. Push spacer (20) by using a press and remove retaining ring (19). 25. Remove spacers (20, 22) and spring (21). W2-6-17