UPPERSTRUCTURE / Swing Device Assemble Swing Motor 1. Install retaining ring (32) and spacer (33) at the rotor (23) side to shaft (31). Install the inner race of roller bearing (34) to shaft (31). 2. Install the outer race and inner ring plate to the inner race of roller bearing (34). Face the stamped mark on inner ring plate to the rotor (23) side. 3. Install other spacer (33) and retaining ring (32) to shaft (31). 4. Install the inner race of roller bearing (1) to shaft (31). Install retaining ring (16) to shaft (31). 5. Install the shaft (31) assembly to casing (30) by using a bar and hammer. 6. Install oil seal (36 to seal cover (37) by using a plate. 7.
Install O-ring (35) to casing (30). IMPORTANT: Apply grease to the inner surface on oil seal (36). Wind the tape onto the spline at the end of shaft (31) in order not to damaging the oil seal. 8. Install seal cover (37) and retaining ring (38) to casing (30). 9. Place casing (30) horizontally with the swing parking brake valve (39) side facing upward. IMPORTANT: Apply grease onto the mating surfaces between casing (30) and shoe plate (29) in order not to fall off. Face the larger chamfered side on shoe plate (29) to casing (30) when installing. 10. Install shoe plate (29) to casing (30). 11. Install spacer (22), spring (21) and spacer (20) to rotor (23) in this order. 12.
Push spacer (20) to the position where retaining ring (19) can be inserted by using a press. Install retaining ring (19). 13. Insert push rods (24) (12 used) to rotor (23). Install spacer (25) and holder (36) in this order. 14. Apply hydraulic oil into the plunger hole on rotor (23). Install plungers (28) (9 used) to retainer plate (27). Insert the plunger (28) assembly into rotor (23). 15. Insert the rotor (23) assembly into casing (31). Hold the rotor (23) assembly by one hand and align the splines while rotating shaft (31) by another hand. 16. Place the casing (30) assembly vertically. W2-6-19