hitachi — ASSEMBLE SWING MOTOR

UPPERSTRUCTURE / Swing Device IMPORTANT: There are four slots on the outer circumstance of plate (18) and four slots on the spline teeth of friction plate (13). When installing, align the slots respectively. 17. Place casing (30) on the wooden block with the reduction side facing downward. Alternately install plates (18) (4 used) and friction plates (13) (3 used). 18. Install O-rings (17, 12) to casing (30). At this time, apply much grease to O-ring. IMPORTANT: Align the slits of brake piston (11) as illustration below. 19. Install brake piston (11) to casing (30). IMPORTANT: When installing, face part R of valve plate (9) opposite to the flange surface of valve casing (3). 22.

Install O-rings (2) and pins (15) (2 used) to valve casing (3). Install valve plate (9) to value casing (3). Flange Surface Valve Casing (3) Valve Plate (9) Part R Screw Hole W17V-02-06-004 Slit NOTE: Apply grease to valve plate (9). Valve plate (9) is prevented from dropping from valve casing (3). IMPORTANT: Align the matching marks made when disassembling and take care in order not to drop valve plate (9). 23. Install valve casing (3) to casing (30). Install valve casing (3) with socket bolts (4) (4 used). Mounting Position for Swing Parking Brake (39) W142-02-06-011 : 17 mm NOTE:

When it is difficult to install brake piston (11) due to resistance of O-rings (12, 17), install the bolt (M8, Pitch 1.25 mm) to brake piston (11). Tap the end of bolt by using a plastic hammer evenly. 20. Install springs (10) (16 used) to brake piston (11). IMPORTANT: Tap the roller bearing (1) type indicated surface by using a plastic hammer and install roller bearing (1). 21. Install the outer race of roller bearing (1) to valve casing (3) by using a plastic hammer. : 627 N m (64 kgf m, 462 lbf ft) 24. Install O-rings (40, 41) to swing parking brake valve (39). Install swing parking brake valve (39) to casing (30) with socket bolts (42) (3 used). : 12 N m (1.2 kgf m, 9 lbf ft) 25.

Install poppets (5) (2 used) and springs (6) (2 used) to valve casing (3). Tighten plugs (8) (2 used) with O-ring (7) attached. : 10 mm : 17 mm : 539 N m (55 kgf m, 398 lbf ft) 26. Install relief valves (14) (2 used) to valve casing (3). : 41 mm : 177 N m (18 kgf m, 130 lbf ft) W2-6-21 B for rake