hitachi — ASSEMBLE SWING BEARING

UNDERCARRIAGE / Swing Bearing Assemble Swing Bearing 3. Clean the groove part for seals (2, 6) completely. Apply THREEBOND #1735 and install seal (2) to outer race (1). Install seal (6) to the groove part on inner race (7). Tighten seal (6) with rod and turnbuckle (9) evenly by 10 to 15 turns. CAUTION: Swing bearing weight: 1250 kg (7560 lb) 1. Align inner race (7) of the swing bearing with the ball groove on outer race (1). IMPORTANT: Apply grease to ball (3) and sup- port (8). 2. Install balls (3) (85 used) and support (8) (85 used) alternately from the plug hole. Install ball (3) first. NOTE: When tightening the turnbuckle, use a round bar (Dia.: 2 to 2.3 mm (0.08 to 0.09 in). 4.

Install plug (5) into outer race (1). Secure plug (5) with pin (4). Crimp the head of pin (4) by using a punch. 2 3 W142-03-01-005 W142-03-01-007 5. Apply much grease to the swing bearing. 8 W142-03-01-006 W142-03-01-004 NOTE: Dia. of support (8): 31.5 mm (1.24 in) Dia. of ball (3): 63.5 mm (2.50 in) W3-1-7 1 5 4 6 4 40±5 mm (1.6 3 ±0.2 in 8