hitachi — DISASSEMBLE TRAVEL DEVICE

UNDERCARRIAGE / Travel Device 15. Put the matching marks on the mating positions of support (9) and drum (10). Remove bolts (8) (12 used). Remove support (9) from drum (10). Remove the inner race of roller bearing (7) from drum (10). CAUTION: Drum (10), others weight: 185 kg (410 lb) 18. Attach a nylon sling onto the body of drum (10). Hoist and lay down drum (10). Install eyebolt (M12, Pitch 1.75 mm) into the bolt (8) hole (2 places) on drum (10). Hoist and turn over drum (10). Remove the outer race of roller bearing (11) from drum (10) by using a bar and hammer. 19. Tap and remove spring pin (39) from the third stage carrier (19) assembly by using a round bar (Dia.:

8 mm (0.05 in)).Remove the pin. Remove third stage planetary gear (38) and thrust plates (37) (2 used) from third stage carrier (19). Remove needle bearings (41) (2 used) from third stage planetary gear (38). 20. Remove spring pins (39) (3 used), pins (40) (3 used), third stage planetary gears (38) (3 used), thrust plates (37) (6 used) and needle bearings (41) (6 used) from third stage carrier (19) according to step 19. Remove spacer (20) from third stage carrier (19). 21. Disassemble the first stage carrier (31) assembly and the second stage carrier (22) assembly according to step 19. Spring Pin (29) Round Bar Dia.: 4 mm (0.2 in) Spring Pin (34) Round Bar Dia.: 5 mm (0.2 in) 22.

Remove spacer (30) from first stage carrier (31). Remove spacer (23) from second stage carrier (22). : 19 mm NOTE: THREEBOND #1215 has been applied to the mating surfaces between support (9) and drum (10). CAUTION: Sprocket (16) weight: 150 kg (330 lb) Drum (10) + sprocket (16) weight: 320 kg (705 lb) 16. Attach a nylon sling to sprocket (16). Turn over sprocket (16). Put the matching marks on the mounting surfaces between sprocket (16) and drum (10). Remove the corks (2) from sprocket (16). Install eyebolt (M27, Pitch 3.0 mm) into the cork hole (2 places). Remove bolts (18) (24 used) and spring washers (17) (24 used). Hoist and removesprocket (16). : 41 mm NOTE:

LOCTITE #262 has been applied to bolt (18). IMPORTANT: Do not remove the outer race of roller bearings (7, 11) from drum (10) unless necessary. Failure to follow these instructions will shorten service life of the bearings as press-fit force is reduced. If removing, replace with a new one when assembling. 17. Remove the outer race of roller bearing (7) from drum (10) by using a bar and hammer. W3-2-11