UNDERCARRIAGE / Travel Device Assemble Travel Device CAUTION: Housing (5) weight: 140 kg (310 lb) 1. Attach a nylon sling onto housing (5). Hoist and place housing (5) with the motor (3) side facing downward. 2. Apply grease onto O-ring in floating seal (6). Install floating seal at one side to housing (5) by using a bamboo spatula. 3. Install floating seal (6) at other side to support (9). Install bolts (8) (12 used) to support (9). Install support (9) to housing (5). CAUTION: Drum (10) and others weight: 175 kg (390 lb) 6. Install eyebolt (M22, Pitch 2.5 mm) into the socket bolt (44) hole (2 places) on drum (10). Attach a nylon sling onto drum (10).
Hoist and place drum (10) with the cover (47) side facing upward. Tap and install the outer race of roller bearing (11) into drum (10) by using a bar and hammer evenly. NOTE: Tap and listen to ring in order to check if the outer race is installed in drum (10) completely. : 19 mm : 90 N m (9 kgf m, 66 lbf ft) 4. Tap and install the inner race of roller bearing (7) into housing (5) by using a bar and hammer evenly. CAUTION: Sprocket (16) weight: 150 kg (330 lb) 7. Install eyebolt (M27, Pitch 3.0 mm) to sprocket (16). Attach a nylon sling onto sprocket (16). Hoist and place sprocket (16) onto the drum (10) assembly. IMPORTANT: Align the matching marks on sprocket (16) and drum (10).
Apply LOCTITE #262 to bolt (18). 8. Insert spring washers (17) (24 used) to bolts (18) (24 used) respectively. Tighten bolt (18) and install sprocket (16) to drum (10). NOTE: Tap and listen to ring in order to check if the inner race is installed in housing (5) completely. CAUTION: Drum (10) weight: 170 kg (370 lb) 5. Install eyebolt (M12, Pitch 1.75 mm) into the bolt (8) hole (2 places) on drum (10). Attach a nylon sling onto drum (10). Hoist and place drum (10) with the cover (47) side facing downward. Tap and install the outer race of roller bearing (7) into drum (10) by using a bar and hammer evenly. : 41 mm : 1400 N m (143 kgf m, 1033 lbf ft) 9.
Apply THREEBOND #1215 onto the drum (10) mounting surface on support (9). Apply hydraulic oil to the inner race of roller bearing (7). NOTE: Tap and listen to ring in order to check if the outer race is installed in drum (10) completely. W3-2-13