UNDERCARRIAGE / Travel Device 14. Install special tool (ST 3140) to bearing nut (13). Tighten bearing nut (13) by using a torque wrench. CAUTION: Drum (10), sprocket (16) and others weight: 330 kg (730 lb) IMPORTANT: Check if the clearance between housing (5) and support (9) is equal all around. 10. Hoist and place the drum (10) assembly onto support (9) gently. IMPORTANT: Align the matching marks on support (9) and drum (10). 11. Install support (9) to drum (10) with bolts (8) (12 used). : 790 N m (81 kgf m, 583 lbf ft) ST 3140 : 90 N m (9 kgf m, 66 lbf ft) 12. Tap and install the inner race of roller bearing (11) into housing (5) by using a bar and hammer evenly. IMPORTANT:
Install bearing nut (13) with the step part facing to the roller baring (11) side. Apply grease to the thread part of bearing nut (13). 13. Install bearing nut (13) to housing (5). Tighten bearing nut (13) by hand. : 19 mm W800-03-02-003 15. Rotate sprocket (16) both clockwise and counterclockwise 4 to 5 turns. Tap the end of drum (10) by using a plastic hammer and take up slack. IMPORTANT: After tightening bearing nut (13), check if bolts (8) (12 used) are loosened. If bolt (8) is loosened, tighten bolt (8) to the specification. 16. Repeat steps 14, 15 and tighten bearing nut (13) to the specification. NOTE:
Apply grease to thread part of bearing nut (13) for keeping correct tightening torque. : 790 N m (81 kgf m, 583 lbf ft) IMPORTANT: If the splines of lock plate (14) and housing (5) are not aligned, turn bearing nut (13) in tightening direction in order to align the splines. Apply LOCTITE #262 to bolt (15). 17. Install lock plate (14) to bearing nut (13) with bolts (15) (2 used). : 90 N m (9 kgf m, 66 lbf ft) 18. Install spacer (20) to third stage carrier (19). : 19 mm W3-2-15