hitachi — DISASSEMBLE TRAVEL MOTOR

UNDERCARRIAGE / Travel Device Disassemble Travel Motor 3. Remove springs (28) (10 used), O-rings (2) (4 used), pins (29) (4 used) and O-ring (27) from case (1). CAUTION: Valve housing (30) weight: 40 kg (90 lb) IMPORTANT: Loosen socket bolts (31) (9 used) evenly. When loosening socket bolt (31), valve housing (30) may come up from case (1) due to reaction force from springs (13, 28). Record the clearance between case (1) and valve housing (30). When removing valve housing (30) from case (1), valve plate (15) is re- moved with valve housing (30). Do not drop valve plate (15). 1. Put the matching marks on the mounting part of valve housing (30) and case (1).

Install eyebolts (M12, Pitch 1.75 mm) to valve housing (30). Re- move socket bolts (31) (9 sued). Hoist and re- move valve housing (30) from case (1). At this time, the outer race of roller bearing (17) is re- moved with valve housing (30). IMPORTANT: Case (1) may move away. Fix case (1) securely. 4. Install eyebolts (M12, Pitch 1.75 mm) into the pin (29) hole (2 places) on brake piston (26). Hoist and remove brake piston (26) from case (1). NOTE: If case (1) moves away, tap the periphery of case (1) by using a plastic hammer. 5. Remove O-rings (23, 24) and backup rings (22, 25) from brake piston (26). CAUTION: The cylinder block (14) assembly weight: 20 kg (40 lb) IMPORTANT:

If cylinder block (14) needs to be re- placed, cylinder block assemblies (10 to 15) including valve plate (15) should be replaced. 6. Place case (1) horizontally with the brake releas- ing oil pressure facing downward. Remove cylin- der block (14) assemblies (10 to 15) from case (1). : 14 mm 30 1 31 NOTE: Hold cylinder block (14) and turn it left and right lightly by two hands. Slowly remove the cylinder block (14) assembly. 7. Remove pistons (10) (9 used), retainer (11), holder (12) and springs (13) (9 used) from cylin- der block (14). Eyebolt Mount- ing Position W16J-03-02-002 IMPORTANT: Do not damage valve plate (15). 2. Remove valve plate (15) and collar (16) from valve housing (30).

IMPORTANT: Disc plates (18, 19, 20) are different in thickness and the order to install them has been determined. Keep in order while removing. 8. Remove disc plate (20) from case (1). Remove friction plates (21) (5 used) and disc plates (19) (4 used) one by one alternately. Remove disc plate (18). W3-2-23