hitachi — DISASSEMBLE TRAVEL MOTOR

UNDERCARRIAGE / Travel Device IMPORTANT: Do not damage the sliding surface of swash plate (9). Piston (4) and steel ball (8) may be removed with swash plate (9). Do not drop piston (4) and steel ball (8). 9. Remove swash plate (9) from case (1). 14. Remove oil seal (7) from case (1). IMPORTANT: Do not remove the inner race of roller bearing (17) from shaft (5) and the outer race of roller bearing (17) from valve housing (30) unless nec- essary. IMPORTANT: When replacing roller bearing (17), do not damage the surfaces of shaft (5) and valve housing. 15. Make a clearance between shaft (5) and the inner race of roller bearing (17) by using a flat chisel and hammer.

Pull out the inner race by using a gear puller. Insert a bar into the clearance between roller bearing (17) and valve housing (30). Pry and re- move the outer race of roller bearing (17) from valve housing (30). 10. Remove pistons (4) (2 used), springs (3) (2 used) and steel balls (8) (2 used) from case (1). NOTE: If it is difficult to remove steel ball (8), clean grease first by using some kerosene or thinner with steel ball (8) set in case (1). Remove steel ball (8) from case (1) by us- ing a magnet. IMPORTANT: Do not damage the spline part of shaft (5) and the contact part of oil seal (7). Oil leakage will occur if they are damaged. 11.

Tap the spline hole in shaft (5) at the most end by using a bar and hammer. Remove shaft (5) from case (1). At this moment, the inner race of roller bearing (6) is removed with shaft (5) together. IMPORTANT: Do not remove the inner race of roller bearing (6) from shaft (5) and the outer race of roller bearing (6) from case (1) unless necessary. 12. Remove the inner race of roller bearing (6) from shaft (5) by using a press. IMPORTANT: Keep the outer race of roller bearing (6) properly so that it can be in- stalled in the same direction before disassembling. 13. Remove the outer race of roller bearing (6) from case (1) by using a bar and hammer. W3-2-25