UNDERCARRIAGE / Travel Device Assemble Travel Motor IMPORTANT: Apply grease on to the inner periph- ery of oil seal (7) for case (1) at the pressed-in part and the outer pe- riphery of oil seal (7). Install oil seal (7) straightly in order not to deform. 1. Press oil seal (7) into casing (1). IMPORTANT: Align the spherical hole in swash plate (9) with steel ball (8) and install swash plate (9). Apply grease to the contacting sur- face of case (1) for swash plate (9). 6. Install swash plate (9) to case (1) with the thicker side facing downward. IMPORTANT: Install friction plates (21) (5 used) to case (1) with their notch position facing into the same direction. 7.
Install disc plate (18) to case (1). Install friction plates (21) (5 used) and disc plates (19) (4 used) alternately. Install disc plate (20) at last. IMPORTANT: Install the outer race of roller bear- ing (6) with the stamped mark on the outer race facing to the swash plate (9) side. 2. Tap the outer race of roller bearing (6) evenly by using a bar and hammer and install the outer race into case (1). NOTE: Disc plates (18, 20) and (19) are in different thickness. (18, 20): 4.8 mm (0.20 in) (19): 3 mm (0.1 in) Align the disc plate with the notch position of case (1) first and install the disc plate. IMPORTANT: Apply hydraulic oil on to the piston (10) mounting hole of cylinder block (14).
Check the direction to install retainer (11). 8. Install springs (13) (9 used) and holder (12) to cylinder block (14). Install pistons (10) (9 used) to retainer (11). Install retainer (11) to cylinder block (14). NOTE: Tap and listen to ring in order to check if the race is installed in case (1) completely. IMPORTANT: Install the inner race of roller bear- ing (6) with the flange part facing to swash plate (9). 3. Tap the inner race of roller bearing (6) evenly by using a bar and hammer and install into shaft (5). Tap and install the shaft (5) assembly to case (1) by using a hammer. IMPORTANT: Apply hydraulic oil onto the outer periphery of steel ball (8) and piston (4).
Apply hydraulic oil onto piston (4) and steel ball (8) mounting sur- face of case (1). 4. Install springs (3) (2 used), pistons (4) (2 used) and steel balls (8) (2 used) to case (1). CAUTION: The case (1) assembly weight: 55 kg (120 lb) 5. Install eyebolt (M18, Pitch 2.5 mm) into the bolt (31) hole (2 places) in case (1). Hoist and place the case (1) assembly onto with the brake releas- ing oil passage facing downward. W3-2-27