hitachi — ASSEMBLE TRAVEL MOTOR

UNDERCARRIAGE / Travel Device IMPORTANT: Check the direction to install brake piston (26). The notch shall be square to the pin (29) mounting holes on case (1). CAUTION: The cylinder block (14) assembly weight: 20 kg (40 lb) IMPORTANT: Apply hydraulic oil to the piston (10) sliding surface of swash plate (9) and the spherical surface of holder (12). The inner race of roller bearing (17) is on the tip of shaft (5). Do not damage them. Align the splines of shaft (5), cylin- der block (14) and friction plate (21). 9. Install the cylinder block (14) assembly onto shaft (5). 1 26 Notch Position CAUTION: The case (1) assembly weight: 55 kg (120 lb) 10.

Install eyebolt (M18, Pitch 2.5 mm) into the socket bolt (31) hole (2 places) in case (1). Hoist and place case (1) vertically. W16J-03-02-003 IMPORTANT: Apply grease to the outer surface of brake piston (26) and the inner sur- face of case (1). 12. Tap brake piston (26) by using a plastic hammer and install brake piston into case (1). IMPORTANT: Apply grease to O-rings (23, 24) and backup rings (22, 25). Check the di- rection to install O-rings (23, 24) and backup rings (22, 25). 11. Install backup rings (25, 22) and O-rings (24, 23) to brake piston (26). IMPORTANT: As for springs (28) (10 used), there are twelve spring (28) mounting holes in brake piston (26).

(Check the piston where spring (28) should be inserted.) Install spring (28) so that the free holes should be in diagonal posi- tion. NOTE: Install backup ring (22) while facing the travel device side. Install backup ring (25) while facing the valve housing (30) side. 26 Free Hole 28 28 W16J-03-02-003 13. Install springs (28) (10 used) onto brake piston (26). Free Hole W3-2-29 29