hitachi — ASSEMBLE TRAVEL MOTOR

UNDERCARRIAGE / Travel Device IMPORTANT: Install the outer race of roller bear- ing (17) with the stamped mark on the outer race facing to the valve plate (15) side. 14. Tap the outer race of roller bearing (17) evenly by using a bar and hammer and install the outer race into valve housing (30). Install the inner race to shaft (5). CAUTION: Valve housing (30) weight: 40 kg (90 lb) IMPORTANT: When installing valve housing (30) to case (1), check if the clearance between case (1) and valve housing (30) is equal to that noted when disassembling. If the value is different, disassemble them and reassemble again. IMPORTANT: Align the matching marks made when disassembling.

If the matching marks cannot be aligned with each other, brake piston (26) may be in- stalled in wrong direction. 17. Install eyebolt (M12, Pitch 1.75 mm) into the bolt hole in valve housing (30). Hoist valve housing. Align with the pin (29) hole in brake piston (26) and place valve housing (30) onto case (1). Install valve housing (30) to case (1) with socket bolts (31) (9 used). NOTE: Tap and listen to ring in order to check if the outer race is installed to valve housing (30) completely. IMPORTANT: Apply grease to the contacting sur- faces of valve plate (15) and valve housing (30). 15. Install collar (16) to valve housing (30).

Align pin (32) with the pin hole on valve plate (15) and in- stall valve plate (15) to valve housing (30). IMPORTANT: Apply grease to O-rings (2, 27). 16. Install O-rings (27) and (2) (4 used) to case (1). Install pins (29) (4 used) to valve housing (30). : 14 mm : 440 ± 22 N m (45 ± 2.2 kgf m, 330 ± 16.0 lbf ft) NOTE: Tighten socket bolts (31) (9 used) evenly. 30 1 31 Eyebolt Mounting Position W16J-03-02-002 W3-2-31