hitachi — DISASSEMBLE TRACK ADJUSTER

UNDERCARRIAGE / Track Adjuster Disassemble Track Adjuster Use a pump unit which has the maximum pres- sure of 69 MPa (700 kgf/cm 2 , 9950 psi) and the flow rate of 8 to 10 liters (2.1 to 2.6 gal). Set the main relief pressure to 49 MPa (500 kgf/cm 2 , 7110 psi) (80 tons) or lower. IMPORTANT: Compress spring (13) until clear- ance between bracket (15) and nut (16) is approximately 10 mm (0.4 in). 2. Loosen valve (17). Compress spring (13) in the track adjuster by using special tool (ST 4932). IMPORTANT: Use special tool (ST 4932) when as- sembling / disassembling the track adjuster. : 24 mm 13 Clearance 10 mm (0.4 in) CAUTION:

Carefully perform disassembly and assembly work as spring force of the track adjuster is extremely large. Thoroughly inspect special tool for any damage in order to perform the work safely. 15 16 18 17 10 CAUTION: Track adjuster weight: 491 kg (1080 lb) 1. Hoist and place the track adjuster on the holder of special tool (ST 4932). W17V-03-04-006 IMPORTANT: Put the matching marks on rod (10) and nut (16). 3. Remove valve (17) and bolt (18). Remove nut (16) from rod (10). ST 4932 : 24 mm, 19 mm, 140 mm Holder W142-03-04-019 W3-4-3