UNDERCARRIAGE / Track Adjuster Assemble Track Adjuster IMPORTANT: Apply grease to wear ring (5), backup ring (6), U-ring (7) and plate (8). Install U-ring (7) with the lip side facing to rod (10). After applying hydraulic oil to the inner surface of cylinder (12) and to rod (10) and piston rod (4), assem- ble them. 1. After cleaning all parts, install wear ring (5), backup ring (6), U-ring (7), plate (8) and retaining ring (9) to piston rod (4). CAUTION: The piston rod (4) assembly weight: 36 kg (80 Ib) IMPORTANT: Fill chamber (B) in cylinder (12) with grease. Insert piston rod (4) and bleed air completely from chamber (B) and from the inside of rod (10). 3.
Fill cylinder (12) fully with grease. Install eyebolt (M16, Pitch 2.0 mm) to the lifting hole on piston rod (4). Attach a nylon sling. Hoist piston rod (4). Install piston rod (4) to cylinder (12) after being applied with grease. IMPORTANT: Fill V-groove in guide (3) with grease. 4. Install O-ring (2) after being applied with grease onto guide (3). Install guide (3) to piston rod (4). Apply LOCTITE #262 to socket bolts (1) (6 used) and tighten. : 140 N m (14 kgf m, 101 lbf ft) : 12 mm W800-03-04-003 CAUTION: Cylinder (12) weight: 65 kg (140 lb) Rod (10) weight: 47 kg (105 lb) 1 Lifting Hole CAUTION: Do not tilt cylinder (12) over. 2.
Install eyebolts (M14, Pitch 2.0 mm) to the socket bolt (1) hole (two places) in the diagonal in cylin- der (12). Attach a nylon sling. Hoist and set cylin- der (12) on the workbench. Apply grease to O-ring (11). Install O-ring (11) to cylinder (12). In- stall eyebolt (M16, Pitch 2.0 mm) to the lifting hole on rod (10). Attach a nylon sling. Hoist and install rod (10) to cylinder (12). W142-03-04-018 NOTE: Clearance of approx. 120 mm (4.7 in) shall be left under cylinder (12) for lowering rod (10). Lifting Hole W17V-03-04-001 W3-4-9 4 5 6 7 8 9 5 6 7 8 9 9 6 7 3 4 2 12 11 Lif 10