hitachi — DISASSEMBLE FRONT IDLER

UNDERCARRIAGE / Front Idler Disassemble Front Idler 1. Remove bolts (10) (4 used) and spring washers (11) (4 used). Remove guard (9) from yoke (12). CAUTION: Bearing (2) weight: 52 kg (115 lb) Idler (7) and other weight: 425 kg (940 lb) Axle (5) weight + bearing (2) weight: 97 kg (215 lb) 4. Set the idler (7) assembly to the press. Remove axle (5) from the idler (7) assembly by using a press. At this time, bearing (2) on other side is removed together with axle (5). : 19 mm CAUTION: The Idler (7) assembly weight: 503 kg (1110 lb) Yoke (12) weight: 71 kg (160 lb) IMPORTANT: Keep idler (7) steady by using the wooden blocks in order to prevent from tilting over. 2.

Attach a nylon sling to yoke (12). Hold idler (7) vertically. Remove bolts (13) (4 used) and spring washers (14) (4 used). Remove yoke (12) from idler (7). Remove plugs (8) (2 used) from the end of bear- ing (2). Tilt idler (7) and drain off oil. Press 2 5 1 7 : 36 mm : 6 mm 3. Put the matching marks on bearing (2) and axle (5). Tap and remove pin (1) from bearing (2) by using a round bar (Dia. 25 mm (1.0 in)) and ham- mer. 2 W17P-03-05-002 W105-03-05-009 5. Remove O-ring (4) from axle (5). W3-5-3 2 3 3 4 5 2 7