hitachi — DISASSEMBLE FRONT IDLER

UNDERCARRIAGE / Front Idler 6. Remove floating seal (3) from idler (7) and bear- ing (2). 7. Put the matching marks on bearing (2) and axle (5). Remove pin (1) from bearing (2) by using a round bar (Dia. 25 mm (1.0 in)) and hammer. IMPORTANT: Do not remove bushing (6) unless necessary. 9. When replacing bushing (6), remove bushing (6) by using special tool (ST 1914) and a press. CAUTION: Axle (5) weight + bearing (2) weight: 97 kg (215 lb) IMPORTANT: Place the wooden blocks or the like etc. under bearing (2) in order to prevent bearing (2) from being damaged. 8. Wind a nylon sling to the axle (5) assembly. Hoist and place the axle (5) assembly on a press.

Re- move axle (5) from bearing (2) by using a press. Remove O-ring (4) from axle (5). ST 1914 6 W105-03-05-011 Block W105-03-05-010 W3-5-5 Press 4 1 2 den k 5 Press 4 2 5 4