UNDERCARRIAGE / Front Idler Assemble Front Idler 4. Apply grease to floating seal (3). Install one float- ing seal (3) to idler (7) and bearing (2). CAUTION: Idler (7) weight: 344 kg (760 lb) 1. Install bushings (6) (2 used) to both sides of idler (7). CAUTION: The axle (5) assembly weight: 97 kg (215 lb) IMPORTANT: Support idler (7) in order to prevent idler (7) from tilting over. 5. Wind a nylon sling to bearing (2) in the axle (5) assembly. Hoist and insert the axle (5) assembly into idler (7) from the side where floating seal (3) is installed. CAUTION: Axle (5) weight: 45 kg (100 Ib) IMPORTANT: Support axle (5) in order to prevent axle (5) from tilting over. 2.
Wind a nylon sling to axle (5). Hoist and place axle (5) vertically. Apply enough grease to O-ring (4). Install O-ring (4) (1 used) to the upper side of axle (5). IMPORTANT: Align the matching marks made when disassembling. 3. Apply grease to the inner surface of bearing (2). Insert bearing (2) to axle (5) at the side where O-ring (4) is installed. Tap the end of bearing (2) evenly by using a plastic hammer while aligning the holes for pin (1). Insert pin (1) into bearing (2) by using a bar and hammer. 2 W157-03-05-006 CAUTION: The idler (7) assembly weight: 441 kg (970 lb) 6. Wind a nylon sling to the idler (7) assembly.
Hoist and place the idler (7) assembly with bearing (2) facing downward. Apply grease to O-ring (4). Install O-ring (4) to axle (5). W105-03-05-014 W3-5-7 7 3 5 5 1 2 4