UNDERCARRIAGE / Upper and Lower Roller Disassemble Upper Roller 6. When replacing bushings (7, 9), remove bushings (7, 9) by using special tool (ST 1967) and a press. 1. Remove plug (2). Drain off oil. : 6 mm 2. Put the matching marks on roller (8) and cover (3). Remove socket bolts (1) (3 used). Remove cover (3) from roller (8). ST 1967 NOTE: Insert a driver between cover (3) and roller (8). Pry and remove cover (3) by using a screwdriver. : 8 mm 7 3. Remove socket bolts (5) (3 used). Remove thrust plate (6) from roller (8). 9 : 8 mm W17V-03-06-002 CAUTION: The axle (10) assembly weight: 26 kg (60 lb) 4. Remove roller (8) from the axle (10) assembly. NOTE:
If no special tool is available, build up weld at the inner diameter of bushing at 4 places in equal distance of 90 ° apart. Shrink and remove the bushing. 5. Remove floating seal (11) from the axle (10) as- sembly and roller (8). 90 ° NOTE: If floating seal (11) should be reused, float- ing seal (11) should be kept with its seal surface covered by cardboard. 90 ° W105-03-05-012 W3-6-9