hitachi — REMOVE AND INSTALL BOOM

FRONT ATTACHMENT / Front Attachment 7. Lower the tube end on boom cylinder onto the support. Start the engine and retract the boom cylinder. In order not to extend the rod, pass a wire through the rod hole and secure the rod to the cylinder tube. Stop the engine. 8. Remove the rod side of other boom cylinder in the same procedures as steps 5, 6. 9. Release any pressure in the front attachment pipe and bleed air in the hydraulic oil tank. (Refer tot W4-1-1, W1-4-1.) Boom Cylinder Support NOTE: Procedures 10, 11 are for the machine equipped with the auto lubrication device (optional). 10. Remove lubrication hose (7). Cap the removed hoses. W1J7-04-01-019 7 : 22 mm 11.

Remove bolt (8) and remove clip (9). 8 : 17 mm 12. Remove socket bolts (11) (16 used) from split flanges (12) (8 used). Remove hoses (10) (4 used). Cap the removed hoses. 9 11, 12 : 12 mm, 14 mm 13. Remove bolts (13) (2 used) and spring washers (14) (2 used) from plate (15) for boom foot pin (16). 10 10 : 30 mm W1J7-04-01-001 NOTE: Put the mark for boom foot position on in- side of the main frame in order to align the boom foot pin (16) holes easily when in- stalling. 13, 14 16 15 W105-04-01-007 Mark Main Frame M116-07-121 W4-1-13