FRONT ATTACHMENT / Cylinder Removal 6. Remove socket bolts (8) (8 used) and split flanges (9) (4 used) from the bottom side of bucket cylinder (2). Remove hoses (2) (2 used) from bucket cylinder (2). Cap the open ends. CAUTION: When tapping the pin by using a hammer, metal fragments may fly off. Prevent personal injury. Be sure to wear necessary protection, such as goggles, a hard hat, etc.. 1. Remove the lubrication hose from the bottom side of bucket cylinder (2). : 12 mm : 19 mm 2. Place the wooden block under link A (1). Secure link A (1) and link B (3) by using a wire in order not to drop links B (3) (2 used) when removing pin (4). CAUTION: Pin (11) weight: 34 kg (75 lb) 7.
Remove bolts (15) (2 used), spring washers (14) (2 used) and plate (13) from the bottom side of bucket cylinder (2). Remove pin (11) from arm (10). : 30 mm CAUTION: Bucket cylinder (2) weight: 680 kg (1500 lb) Pin (4) weight: 94 kg (210 lb) 3. Attach a nylon sling to bucket cylinder (2) and hold bucket cylinder (2). Remove bolts (7) (3 used), spring washers (6) (3 used) and stopper (5) from the cylinder rod side. Remove pin (4) from link B (3) and link A (1). CAUTION: Bucket cylinder (2) weight: 680 kg (1500 lb) 8. Hoist and remove bucket cylinder (2) from arm (10). : 30 mm 4. Start the engine. Retract the cylinder rod to the stroke end.
Pass a wire through the cylinder rod hole and secure the rod in order not to extend bucket cylinder (2). CAUTION: Do not turn the cap on hydraulic oil tank quickly. The cap may fly off by internal pressure. Release any remaining pressure and remove the cap. 5. Stop the engine. Release any remaining pressure in the hydraulic lines and oil tank. (Refer to W4-2-14.) W4-2-11