1-9 REPLACING BATTERY PLUG TERMINAL 1. Disconnect battery plug cable one by one. Caution: Never disconnect more than one cable at the same time.Fatal accident may result by short circuit. 2. Insert a screwdriver from the terminal side, push down the spring at the bottom of the terminal and pull the cable to draw out the terminal. Terminal Screw driver Spring Spring 3. Peel off the tip of the cable for Approx. 30mm, solder sufficiently and insert it to the contact portion of the new terminal. Note: Be sure to prevent solder from pouring out and adhere to the contact surface of the terminal. 4. When crimping cables, never bend the terminal with a crimping tool. 5.
Insert the terminal to the battery plug. Check that the tip of the terminal goes over the tip of the spring and securely set in the position. Cr imping method Crimping tool Pad (To prevent the contact piece from bending) Case Terminal spring Cable