Toyota — MAGNETIC SWITCH ASSY

2-10 Point Operations [POINT 1] Inspection: Magnetic switch contact continuity inspection. Inspection: Magnetic switch coil continuity inspection. CLK-35JT-F 400 Ω Inspection: Thermal relay contact continuity inspection. Inspection: Inspect the reset switch. Check that the thermal relay is deactivated upon pressing the reset switch while the thermal relay is activated.Do not adjust the thermal relay operating current. If charging stops due to thermal relay activation while the charger is in use, always check the thermal relay activating cause and reset after taking corrective action. Test switch Reset switch Press the reset switch lightly to reset the thermal relay.

* Test the thermal relay as follows: Press the reset switch. Tester range Ω × 1 Measurement terminals T−W, S−V and R−U Standard: MSch ON 0 Ω MSch OFF ∞ Ω Tester range Ω × 1 Measurement terminals A1−A2 CLK-20JT-F 700 Ω Tester range Ω × 1 Measurement terminals 95−96 Standard: Not operating 0 Ω Operating ∞ Ω 96 95 No operated 96 95 Operated