Operation Section • Display for Troubleshooting Operation This system can be basically operated in two preselected modes, automatic mode and manual mode. NOTE: In ASC-200 factory-setting controller, automatic mode is selected for both direction inhibit and two-speed auto shift control as a default on the PCB(Printed Circuit Board).In ASC-201 factory-setting controller, manual mode(Fail-Safe Mode) is selected as a default for direction inhibit while automatic mode is selected as a default for two-speed auto shift control. Automatic mode This information is input for signal diagnostics. This test is used to verify operation of direction control lever. 1.
Start the engine with the direction control lever in NEUTRAL and the parking brake engaged. 2. Press down on the service brake pedal, disengage the parking brake and move the direction control lever to FORWARD. NOTE: Release the parking brake before using the directional control lever. 3. Observe the LED on the Auto Shift Controller. The LED should indicate "A" while the direction control lever is in FORWARD, NEUTRAL and REVERSE. Report Auto Shift as faulty if the LED indicates anything other than "A". 4. Keep the service brake pushed down until ready to move the truck. 5.
To change directions of a traveling lift truck when the Auto Shift Controller LED displays "A", shift the direction control lever to the opposite direction and wait for the lift truck to change direction. 6. If however, your travel speed is higher than the pre-selected direction change speed as direction inhibit point in the controller, Auto Shift will shift the transmission to NEUTRAL until the lift truck's travel speed slows to the pre-selected direction change speed, and then shift the transmission to the direction selected. 7. You should be prepared to help slow the lift truck to the pre-selected direction change speed by pressing down on the service brake pedal.
Direction Inhibit 109 Display Description Remark A Automatic operation 2 High speed s/w input Lever input test 3 Forward s/w input Lever input test 4 Reverse s/w input Lever input test