Maintenance Section Lubricant Specifications Lubricant Information Some classifications and abbreviations we use in this section follow S.A.E. (Society of Automotive Engineers) J754 nomenclature and others follow S.A.E. J183. All MIL specifications are U.S.A. Military. Recommended oil viscosities are given in the "Lubricant Viscosities" chart later in this section of the manual. Greases are classified according to the National Lubricating Grease Institute (NLGI) based on ASTM D217-68 worked Penetration characteristics which give a defined consistency number. Engine Oil (DEO and EO) The following oil specifications provide guidelines for the selection of commercial products :
.Gasoline/LP Engine : API SJ .Diesel Engine : API CH4 or ACEA E5 Hydraulic Oil (HYDO) The following commercial classifications can be used in the hydraulic system. z ISO 6743/4 HM z AFNOR NFE 48-603 HM z CINCINNATI P68, 69, 70 Viscosity : ISO VG32 Industrial premium hydraulic oils that have passed the Vickers vane pump test (35VQ25). These oils should have antiwear, antifoam, antirust and antioxidation additives for heavy duty use as stated by the oil supplier. ISO viscosity grade of 32 would normally be selected.
Transmission Oil (TDTO) z DIN 51524 TEIL 2 H-LP z HAGGLUNDS DENISON HFO-HF2 NOTICE These oils are formulated for transmissions and drive trains only, and should not be used in engines. Shortened engine life will result. NOTICE Failure to follow the oil recommendations can cause shortened engine life due to carbon deposits or excessive wear. NOTE: Multi-grade oils are not blended by DOOSAN for use in transmissions. Multi-grade oils which use high molecular weight polymers as viscosity index improvers lose their viscosity effectiveness by permanent and temporary shear of the viscosity index improver and therefore, are not recommended for transmission and drive train compartments. NOTE:
Failure to follow this recommendation can cause shortened transmission life due to material incompatibility, inadequate frictional requirements for disk materials and/or excessive gear wear. Select Oil that meets below specifications. Consult the EMA Lubricating Oils Data Book for a listing of oil brands. NOTE: The percentage of sulfur in the fuel will affect the engine oil recommendations. For fuel sulfur effects, the Infrared Analysis or the ASTM D2896 procedure can be used to evaluate the residual neutralization properties of engine oil. The sulfur products formation depends on the fuel sulfur content, oil formulation, crankcase blowby, engine operating conditions and ambient temperature.
z D50/60/70/80/90S-5(3 Speed) : API CD/TO-2 or MIL-L-2104D,E z D50/60/70S-5 (2 Speed), G50/60/70S-5 : GM DEXRON 132