Safety Section Operate the lift truck and controls only from the operator's station. Make sure the lift truck horn, lights, backup alarm (if equipped) and all other devices are working properly. Check for proper operation of mast and attachments. Pay particular attention to unusual noises or erratic movement which might indicate a problem. Make sure service and parking brakes, steering, and directional controls are operational. Make sure all personnel are clear of lift truck and travel path. Refer to the topic "Lift Truck Operation" in the "Operation Section" of this manual for specific starting instructions.
Starting the Lift Truck Operating the Lift Truck Always keep the lift truck under control. Obey all traffic rules and warning signs. Never leave the lift truck with the engine operating, or with the parking brake disengaged. Operate the engine only in a well ventilated area. Lower the mast, with or without load, before turning or traveling. Tip over could result. Watch out for overhead obstructions. Always observe floor load limits and overhead clearance. Start, turn, and brake smoothly. Slow down for turns, grades, slippery or uneven surfaces. Watch the road carefully for any obstacle when driving the truck.
Do not go fast over bumps, pot holes or other rough grounds, otherwise the engine might go OFF by a severe impact. In case of engine going OFF, press the brake pedal at one time as hard as possible in order to stop the truck. Pressing the brake pedal several times has a risk that the brake would not work. Do not start the engine or move any of the controls if there is a "DO NOT OPERATE" or similar warning tag attached to the start switch or controls. Before Operating the Lift Truck Test brakes, steering controls, horn and other devices for proper operation. Report any faulty performance. Do not operate lift truck until repaired. Learn how your lift truck operates. Know its safety devices.
Know how the attachments work. Before moving the lift truck, look around. Start, turn and brake smoothly. An operator must constantly observe his lift truck for proper operation. Use special care when operating on grades. Do not angle across or turn on grades. Do not use a lift truck on slippery grades. Travel with forks downgrade when unloaded. Travel with load upgrade. Do not overload, or handle offset, unstable, or loosely stacked loads. Refer to load capacity plate on the lift truck. Use extreme caution when handling suspended, long, high or wide load. 12