Doosan D80S-5 — Doosan D80S-5 User Manual

Maintenance Section Engine Oil & Filter(LP Engine Only) - Change 10. Fill the crankcase. See " Refill Capacities ". 11. Start the engine and allow the oil to fill the filter and passages. 12. Check for oil leaks. LP Engine Crankcase 1. Operate lift truck a few minutes to warm oil. Park the lift truck with the forks lowered, parking brake applied, transmission in neutral and the engine stopped. 2. Raise rear of lift truck off ground and block securely. 13. Stop the engine and measure the oil level. Maintain the oil level to the FULL mark on the dip stick. 14. Close hood and seat assembly. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. 3.

Remove the crankcase drain plug and allow oil to drain. Clean and install drain plug. 4. Raise the hood and seat assembly. 5. Remove and discard oil filter element. 6. Wipe sealing surface of oil filter element mounting base. Make sure all of the old gasket is removed. 7. Before installing a new filter element, apply a small amount of clean engine oil to the filter element gasket. 8. Install the new filter element. When the gasket contacts the base, tighten it 3/4 of a turn more. Do not overtighten. 9. Raise the lift truck, remove the blocking and lower the lift truck. 163 WARNING