Doosan D80S-5 — Doosan D80S-5 User Manual

Maintenance Section Fork – Inspect 3. Check the straightness of the upper face of blade (D) and the front face of shank (E) with a straight edge. The fork should be withdrawn from service if the deviation from straightness exceeds 0.5 percent of the length of the blade and/or the height of the shank respectively 5 mm/1000 mm (0.18"/36"). Forks should be inspected, at a minimum, every 12 months. If the truck is being used in a multi-shift or heavy duty operation, they should be checked every six months. 1. Inspect the forks carefully for cracks. Special attention should be given to the heel section (A), all weld areas and mounting brackets (B).

Inspect the top and bottom hooks on forks used on hook type carriages and tubes on shaft mounted forks. Forks with cracks should be removed from service. "Wet Test" magnetic particle inspection is generally preferred due to its sensitivity and the ease of interpreting the results. Portable equipment is usually recommended so it can be moved to the lift truck. Inspectors should be trained and qualified in accordance with The American Society for Non Destructive Testing, Level II Qualifications. 4. Check the difference in height of one fork tip to the other when mounted on the fork carrier.

A difference in fork tip height can result in uneven support of the load and cause problems with entering loads. The maximum recommended difference in fork tip elevation (F) is 6.5 mm (0.25") for pallet forks and 3 mm (0.125") for fully tapered forks. The maximum allowable difference in fork tip elevation between the two or more forks is 3 percent of blade length (L). Replace one or both forks when the difference in fork tip height exceeds the maximum allowable difference. Contact your local DOOSAN Lift Truck Dealer for further information. 2. Check the angle between the upper face of the blade and the front face of the shank.

The fork should be withdrawn from service if angle (C) exceeds 93 degrees or deviates by more than 3 degrees from an original angle other than 90 degrees, as may be found in some special application forks. 183