Doosan D80S-5 — Doosan D80S-5 User Manual

Operation Section Table 2. MI-07 Diagnostic Fault Codes (Flash Codes) (*) Fault actions shown are default values specified by the OEM.

91 DFC PROBABLE FAULT FAULT ACTION * CORRECTIVE ACTION FIRST CHECK 12 NONE Signifies the end of one pass through the fault list NONE None, used as end of the fault list identification 141 (14) ECTRangeLow Coolant Sensor failure or shorted to GND TurnOnMil Check ECT sensor connector and wiring for a short to GND SECM (Signal) Pin B15 To ECT Pin 3 SECM (Sensor GND) Pin B1 to ECT Pin 1 SECM (System GND) Pin A16, B17 151 (15) ECTRangeHigh Coolant sensor disconnected or open circuit (1) TurnOnMil (2) DelayedEngine Shutdown (3) CheckEngineLight Check if ECT sensor connector is disconnected or for an open ECT circuit SECM (Signal) Pin B15 to ECT Pin 3 SECM (Sensor GND) Pin B1 to ECT Pin 1 161 (16) ECTOverTempFault Engine coolant temperature is high.

The sensor has measured an excessive coolant temperature typically due to the engine overheating. (1) TurnOnMil (2) DelayedEngine Shutdown (3) CheckEngineLight Check coolant system for radiator blockage, proper coolant level and for leaks in the system. Possible ECT short to GND, check ECT signal wiring SECM (Signal) Pin B15 to ECT Pin 3 SECM (Sensor GND) Pin B1 to ECT Pin 1 SECM (System GND) Pin A16, B17 Check regulator for coolant leaks 171 ECT IR Fault _ _ Engine coolant temperature not changing as expected None Check for coolant system problems, e.g.

defective or stuck thermostat 181 FuelSelectConflict Conflict in fuel select signals, normally set if both of the fuel select signals are shorted to ground TurnOnMil Check fuel select switch connection for a short to GND SECM (SIGNAL) Pin A12 SECM (SIGNAL) Pin A15 SECM (Sensor GND) Pin B1 193 CrankEdgesFault No crankshaft signal when engine is known to be rotating, broken crankshaft sensor leads or defective crank sensor None Check Crankshaft sensor connections SECM (SIGNAL) Pin B5 to Crank sensor Pin 3 SECM (Sensor GND) PIN B1 to Crank sensor Pin 2 Switched 12V to Crank sensor Pin 1 Check for defective Crank sensor