Doosan Mega 500-V (Tier II) — Engine Fault Codes

ENGINE DIAGNOSTIC SWITCH If the engine check light (Yellow) or the engine stop light (Red) or the engine maintenance light (Blue) comes on when the engine is running, it means a fault code has been recorded. O During this time, the engine diagnostic switch allows the operator to view the fault codes. I The severity of the fault will determine the light that will come "ON" and the active fault codes can be viewed using the engine stop light as described below. AQO0120L To view the fault codes: Figure 21 1. Engine must be shut off (not running) 2. Starter switch must be in the "ON" position. 3. Engine diagnostic switch must be in the "I" position.

The engine stop and check lights flash if there are any fault codes to display. If there are no fault codes to display, the engine stop and check lights will remain lit. ENGINE FAULT CODES If there are fault codes to be displayed, the engine check light will flash momentarily. Then the engine stop light will flash the first, second and third digits of the fault code. 1 2 3 1. Engine Stop Light (Red) 2. Engine Check Light (Yellow) 3. Engine Maintenance Light (Blue) STOP STOP STOP CHECK CHECK CHECK CHECK AWS0550L Figure 22 S0802195K Page 36 Electrical System