MECHANICAL SPECIFICATION (PEDAL SENSOR) 1. Rotating Angle: 83 ° ± 2 ° 2. Spring Return Force: 150 ~ 200 Nm at 40 ° ± 2 ° DATA LINK The ECM (Electronic Control Module) communicates with service tools through an SAE J1939 data link or SAE J1708 datalink. Insite Using Insite, the data link permits limited modification of ECM features and parameters, and downloading of entire ECM calibrations. NOTE: To use a Insite, you need a data link harness designed by DHIM. NOTE: The 4-pin AMP connector, is used as engine-side data link, is located in the electric box.
4P 4 9P Datalink Harness 3 1 2 C F E D G J B H A AWS0570L Figure 25 LIS (LOAD ISOLATION SYSTEM) - OPTION Excessive bucket pitching is drastically reduced and good floatation is maintained for minimum operator fatigue and maximum productivity. LIS is useful for sites where frequent cycles of loading and carry are needed or rough terrain. O When the LIS switch is in the "I" position and vehicle speed is above 8 km/h, the LIS solenoid valves(14) are energized and the LIS system is "ON". I When the LIS switch is in the "I" position and vehicle speed is below 6 km/h, the LIS solenoid is de-energized and the LIS system is "OFF". HA0O2026 NOTE:
If the switch is in the '0' position, regardless of the vehicle speed the LIS solenoid valves (14) de- energized and the LIS system is not operating. Figure 26 S0802195K Page 46 Electrical System