. OPERATION TRANSPORTATION position (L). NOTICE 3 - 160 The mac hine can be lifted only if it has hook mark labels. When lif ting the machine, stop the machine on level ground and do 1. Start the engine, make sure t hat the machine is horizontal the travel posture. MACHINE (PAGE 3-125)". then For (A): set the work equipment to details, see "MOVING THE MACHINE (PAGE 3-125)". 40 - 50 cm (16 - 20 in) 2. Che ck that the work equipme nt control lever is at the HOLD ion, then set the work equ LOCK 3. Stop the engine, check that t he area around the operator's com posit artic partment is safe, then set t he frame lock bar to the LOCK ion (L) to prevent the fro ulating.
nt frame and rear frame from 4. Use wire ropes and slings that match the weight of the machine , and wind the wire ro pe and fix it to the lifting poin ts as shown in the figure. Use pr otectors, etc. so that the wire ropes will not be broken at sharp Use th readers and bars having suffi cient width so that the sling s and wir e ropes will not touch the For ma chines equipped with a rear f ull fender, remove the rear f ull fender before carrying out the 5. Befo re lifting up the machine, s et the slings and float the machine to 100 mm - 200 mm a bove the ground. Make sure that the wire ropes are no t slack and the machine i s kept horizontally, and then lift up the machine slowly.