. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the oil under drain plug (P), then Tightening torque: 68.6 ± 9.8 Nm (7.0 ± 1.0 kgm, 50.6 ± 7.2 lbft) 4 - 56 1. remove drain plug (P) an To prevent the oil from po (P) and remove it gradual 2. After draining the oil, inst 3. Set a container to catch t he oil under the transmission fi lter. 4. Remove drain plug (1) of the transmission filter, drain the oil, n. then tighten the plug agai 5. Using a filter wrench, turn filter cartridge (2) to the left to re move it. 6. Clean in the filter holder, c new filter cartridge with e oat the seal surface and thread of the ngine oil, then install it. 7.
When the seal surface co mes into contact with the filter h older, tighten a further 2/5 turns with the filter wrench. 8. Remove 4 bolts (3), move tube (4), then remove straine r (5) . 9. Remove any dirt stuck t o strainer (5), then wash it in clean 10. diesel fuel or flushing oil. If strainer (5) is damaged, replace it with a new part. Install strainer (5) in the c ase. Replace the O-ring of tube (4) with a new part, then install tube (4). 11. Refill the specified quanti ty of oil through oil filler (F). that the oil is at the specified level. 12. After filling with oil, check that the oil is at the specified level. For details, see "CHECK TRANSMISSION OIL LEVEL, ADD OIL (PAGE 4-24)".
Check that there is no le case or oil filter. akage of oil from the transmission 13.