. OPERATION EXPLANATION OF COMPONENTS (1) (2) (3) (4) (5) (6) (6) (6) (7) (8) (9) (10) (11) (12) Starting switch Power mode selector switch Transmission shift mode selector switch Transmission cut-off switch Transmission cut-off set switch Lamp switch Turn signal lever Dimmer switch Horn button Hazard lamp switch Parking brake switch Front working lamp switch Rear working lamp switch Machine monitor mode selector switch 1 (13) (14) (15) (16) (17) (18) (19) (20) (21) Machine monitor mode selector switch 2 Kickdown switch Hold switch Front wiper switch Rear wiper switch Cigarette lighter Room lamp switch Rear heated wire glass switch E.C.S.S.
(electronic controlled suspension system) switch Emergency steering switch Cooling fan reverse rotation switch Torque converter lock-up switch (if equipped) (22) (23) (24) STARTING SWITCH This switch (1) is used to start or stop the engine. (A): OFF position It is possible to insert and remove the starting switch key, all the electric system switches are turned off, and the engine stops. In addition, the parking brake is automatically applied. (B): ON position In this position, electric current flows in the charging and lamp circuits. Keep the starting switch key at the ON position while the engine is running.
If the ambient temperature is low, when the engine is started, the preheating pilot lamp will light up automatically and preheating will start. The preheating time differs according to the ambient temperature when the engine is started. If the preheating pilot lamp lights up, wait for it to go out, then turn the key to the START position. (C): START position This is the position to start the engine. Hold the key at this position while cranking the engine. Release the key immediately after the engine has been started. The key will return to ON position (B) when released 3 - 40