Komatsu — HANDLING HYDRAULIC SYSTEM

MAINTENANCE OUTLINE OF SERVICE RELATING TO ELECTRIC SYSTEM It is extremely dangerous if the electrical equipment becomes wet or the covering of the wiring is damaged. This will cause electrical leakage and may lead to malfunction of the machine. Do not wash the inside of the operator's cab with water. When washing the machine, be careful not to let water get into the electrical compo- nents. Service relating to the electric system is check of fan belt tension, check of damage or wear in the fan belt and check of battery fluid level. Never install any electric components other than there specified by Komatsu.

External electrical interference may cause malfunction of the control system controller, so before installing a radio receiver or other wireless equipment, please contact your Komatsu distributor. When working at the seashore, carefully clean the electric system to prevent corrosion. When installing an operator's cab cooler or any other electrical equipment, connect it to an independent power source connector. The optional power source must never be connected to the fuse, starting switch, or battery relay. HANDLING HYDRAULIC SYSTEM The hydraulic equipment is at high temperature during operations or after completion of operations.

In addi- tion, it is also under high pressure during operations, so pay careful attention to the following points when car- rying out inspection and maintenance of the hydraulic system and components. Stop the machine on level ground, lower the dump body, and take action to ensure that no pressure is applied to the cylinder circuit. Always stop the engine. Immediately after stopping operations, the hydraulic oil and lubricating oil is at high temperature and high pressure, so wait for the temperature at all parts to go down before starting maintenance.

Even when the temperature goes down, some parts may be under internal pressure, so when loosening plugs, threads, or hose connections, do not stand immediately in front of the part. Loosen the parts slowly to release the internal pressure before removing them. When carrying out inspection and maintenance of the hydraulic circuit, always release the air from the hydraulic tank to remove the internal pressure. Inspection and maintenance includes inspection of the hydraulic oil level, replacement of filters, and changing the hydraulic oil. When removing high-pressure hoses, check that there is no damage to the O-ring. If any damage is found, replace.

If the hydraulic filter element, strainer, or other parts have been replaced or washed, or if any hydraulic equip- ment has been repaired or replaced, or hydraulic piping has been removed, it is necessary to bleed the air from inside the circuit. 4-9