Komatsu — TORQUE LIST

STANDARD TIGHTENING TORQUES FOR BOLTS AND NUTS MAINTENANCE STANDARD TIGHTENING TORQUES FOR BOLTS AND NUTS TORQUE LIST CAUTION If nuts, bolts, or other parts are not tightened to the specified torque, it will cause looseness or damage to the tightened parts, and this will cause failure of the machine or problems with operation. Always pay careful attention when tightening parts. Unless otherwise specified, tighten the metric nuts and bolts to the torque shown in the table below. The tightening torque is determined by the width across the flats of the nut and bolt. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced.

Apply the following table for Hydraulic Hose.

4-14 Thead diameter a(mm) Width across flat b(mm) Tightening torque [N•m (kgf•m)] Target value Service limit 6 8 10 12 14 10 13 17 19 22 13.2 (1.35) 31 (3.2) 66 (6.7) 113 (11.5) 177 (18.0) 11.8 - 14.7 (1.2 - 1.5) 27 - 34 (2.8 - 3.5) 59 - 74 (6.0 - 7.5) 98 - 123 (10.0 - 12.5) 157 - 196 (16.0 - 20.0) 16 18 20 22 24 24 27 30 32 36 279 (28.5) 382 (39.0) 549 (56.0) 745 (76.0) 927 (94.5) 245 - 309 (25.0 - 31.5) 343 - 425 (35.0 - 43.5) 490 - 608 (50.0 - 62.0) 662 - 829 (67.5 - 84.5) 824 - 1030 (84.0 - 105.0) 27 30 33 36 39 41 46 50 55 60 1320 (135.0) 1720 (175.0) 2210 (225.0) 2750 (280.0) 3280 (335.0) 1180 - 1470 (120.0 - 150.0) 1520 - 1910 (155.0 - 195.0) 1960 - 2450 (200.0 - 250.0) 2450 - 3040 (250.0 - 310.0) 2890 - 3630 (295.0 - 370.0) Thread diameter a(mm) Width across flat b(mm) Tightening torque [N•m (kgf•m)] Target value Service limit 14 19 44.1 (4.5) 34.3 - 63.7 (3.5 - 6.5) 18 24 78.5 (8.0) 58.8 - 98.1 (6.0 - 10.0) 22 27 117.7 (12.0) 88.3 - 137.3 (9.0 - 14.0) 24 32 147.1 (15.0) 117.7 - 176.5 (12.0 - 18.0) 30 36 215.7 (22.0) 176.5 - 245.2 (18.0 - 25.0) 33 41 255.0 (26.0) 215.7 - 284.4 (22.0 - 29.0)