MAINTENANCE SERVICE PROCEDURE 8. Stop the engine and open drain valve (4) and remove drain plug (5) to drain the water. 9. After draining the water, clean the cooling system with cleaning agent. For the cleaning method, see the instructions for the cleaning agent. 10. Close drain valve (4) and install cover (3). Wind seal tapes onto drain plug (5), then tighten it. 11. Add water through the water filler up to the filler port. Decide the proportions of antifreeze and water according to the table for the mixing rate of water and antifreeze. 12. Run the engine idle at a low speed 5 minutes, then at a high speed for 5 minutes to bleed air mixed in the cooling water.
(At this time, keep the water filler cap removed.) 13. Drain the cooling water inside sub-tank (6), clean the inside of the sub-tank, then fill again with cooling water to a point midway between the FULL and LOW marks. If the sub-tank is extremely dirty and it is difficult to clean, replace it with a new part. 14. Stop the engine and tighten the radiator cap (2). Check the coolant level and add water if necessary. 4-25