ATTACHMENTS, OPTIONS CAR COOLER PRECAUTION WHEN USING To use the car cooler efficiently, pay careful attention to the following. If the suction port at the front of the car cooler body is blocked, the cooler efficiency will become poor. Always ensure that there is a good flow of air. If the machine has been left in the sun for a long time and the temperature inside the cab is high, open the win- dows and doors to cool the cab down before turning on the cooling. Keep the windows and doors closed when using the cooler. If dirt or mud accumulates on the condenser, the cooling efficiency will become poor.
When washing or inspecting the machine, wash off all dirt and mud accumulated on the condenser to improve the air flow. Generally speaking, when using the cooler, for health reasons, the optimum setting is to have the temperature when entering the cab feel slightly cooler than the outside air (5 - 6єC below the outside temperature). Always keep this in consideration when adjusting the temperature. CAR COOLER MAINTENANCE WHEN REQUIRED CHECK LEVEL OF REFRIGERANT(GAS) WARNING If the refrigerant used in the cooler gets into your eyes or on your hands, it may cause loss of sight or frostbite. Do not touch the refrigerant. Never loosen any part of the refrigerant circuit.
Do not bring any flame close to any point where the refrigerant gas is leaking. If there is a lack of refrigerant (gas), the cooling performance will be poor. When operating the cooler at high speed with the engine at full throttle, use the receiver sight glass (inspection window) to check the condition of the refrigerant gas (Freon R134a) flowing in the refrigerant circuit. No bubbles in refrigerant flow: Suitable Some bubbles in flow (bubbles pass continuously): Lack of refrigerant Colorless, transparent: No refrigerant REMARK When there are bubbles, the refrigerant gas level is low, so contact your refrigerant dealer to have refrigerant added.
If the air conditioner is run with the refrigerant gas level low, it will cause damage to the compressor. 6-3