EXPLANATION OF COMPONENTS OPERATION FUSIBLELINK If the starting motor does not move even when the starting switch is turned to the ON position, there is probably a break in the wire-shaped fusible link (1), so open the engine hood and check or replace. REMARK A fusible link refers to the large-sized fuse wiring installed in the high current flow portion of the circuit to protect electrical components and wiring from burning, in the same way as an ordinary fuse. POWER SUPPLY TAKE-OFF PORT NOTICE When installing electric equipment other than that provided by Komatsu, use equipment with a maximum of 36W (15A or equivalent) on the 24V specification machine.
If any electrical equipment with a larger capacity used to be used, please contact your Komatsu distributor. The power supply take-off connector (1) (M30) for options is at the bottom rear of the operator's compartment. For details of the type of connector, see the table below. TOOL BOX This is under the operator's seat. This is used for keeping the tools. 3-28 M type housing (2-pin) Terminal Body Rear holder AVS 0.5 M.AVS 0.85-2 M.AVS3 Komatsu Part No. 08056-00211 08056-00230 08056-00050 08056- 00051 08056-00052