EXPLANATION OF COMPONENTS OPERATION HANDLING ACCUMULATOR WARNING The accumulator is charged with high-pressure nitrogen gas, so mistaken operation may cause an explo- sion, which will lead to serious injury or damage. When handling the accumulator, always do as follows. The pressure in the control circuit cannot be completely removed. When removing the hydraulic equipment, do not stand in the direction that the oil spurts out when carrying out the operation. Loosen the bolts slowly. Do not disassemble the accumulator. Do not bring it near flame or dispose of it in fire. Do not make holes in it or weld it. Do not hit it, roll it, or subject it to any impact.
When disposing of the accumulator, the gas must be released. Please contact your Komatsu distributor to have this work carried out. This machine is equipped with an accumulator in the control circuit. The accumulator is a device to store oil pressure for the control circuit, and when it is installed, the control circuit can be actuated for a short time even after the engine is stopped. Due to this device, the work equipment lowers under its own weight, if the control lever is moved in the lowering direction. The accumulator is installed to the position shown in the dia- gram on the right.
METHOD FOR RELEASING PRESSURE IN ACCUMULATOR CONTROL CIRCUIT WARNING The hydraulic system is always under internal pressure, so when inspecting or replacing the piping or hoses, always release the pressure in the circuit before starting. If the pressure is not released, high- pressure oil may spurt out and cause serious personal injury. When the oil filler cap is removed, oil may spurt out, so turn the cap slowly to release the pressure before removing the cap. Take note, however, that the remaining internal pressure can hardly be released completely.
When disconnecting the hydraulic circuit for the work equipment, therefore, loosen the screw slowly and do not stand in the direction that oil may spurt out. 1. Stop the machine on firm level ground. 2. Lower the dump body until it contacts the stopper. 3. Stop the engine, then remove the key from the staring switch. 3-30