Group 43 MID 130 Transmission Control Unit, Fault Codes MID 130 PPID 10 Gear Selector Cylinder 1, Position MID 130 PPID 11 Gear Selector Cylinder 2, Position 24 Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause:
FMI 3 • Voltage above normal or shorted high • Status from ASIC is short circuit to U-BATT • Yellow lamp is sent • Slow gear changes • N/A FMI 5 • Current below normal or open circuit • Status from ASIC is open circuit • Yellow lamp is sent • Slow gear changes • N/A FMI 6 • Current above normal or grounded circuit • Status from ASIC is short circuit to ground • Yellow lamp is sent • Slow gear changes • N/A FMI 13 • Calibration value out of range • The checksum in NVRAM is not correct or • The sensor has not been calibrated • Yellow lamp is sent • Cranking is inhibited • Engine cannot start • N/A Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause:
FMI 3 • Voltage above normal or shorted high • Status from ASIC is short circuit to U-BATT • Yellow lamp is sent • Slow gear changes • N/A FMI 5 • Current below normal or open circuit • Status from ASIC is open circuit • Yellow lamp is sent • Slow gear changes • N/A FMI 6 • Current above normal or grounded circuit • Status from ASIC is short circuit to ground • Yellow lamp is sent • Slow gear changes • N/A FMI 13 • Calibration value out of range • The checksum in NVRAM is not correct or • The sensor has not been calibrated • Yellow lamp is sent • Cranking is inhibited • Engine cannot start • N/A