Group 43 MID 130 Transmission Control Unit, Fault Codes MID 130 PSID 232 Powertrain CAN MID 130 PSID 254 DIEE Signal 48 Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause: Note: This fault code is valid for vehicles where a CAN 2 data link exists between the TCM and the engine FMI 2 • Data erratic, intermittent, or incorrect • CAN 2 data link communication does not work • Yellow lamp is sent • Slow gear shifts • N/A FMI 9 • Abnormal update rate • Message missing on SAE J1939 data link from the following control module: Engine Control Module (ECM) • Yellow lamp is sent • Slow gear shifts • N/A Type of fault: FMI Description: Fault Condition: Possible Symptoms:
Possible Cause: FMI 3 • Voltage above normal or shorted high • The voltage level for the DIEE pin is high • Yellow lamp is sent • Cranking is inhibited • Engine cannot start • All communication with the control module is disabled except for programming of MSW • N/A